The Martin ExperienceC4.8T, C.6.8T, C8.1TUser’s GuideAll material © 2007. Martin Audio Ltd. Subject to change without notice.
Step 8 Push the grille into position ensuring that the grille is properly located in the baffle slots. Locate grille tags into slots Your Martin A
All material © 2007. Martin Audio Ltd. Subject to change without notice. Installation Guide Martin Audio Ceiling Loudspeakers C4.8T, C6.8T, C8.1
A steel cover plate with a clamped cable entry protects the input connector against fire in accordance with BS5839: Part 8, Section 10.3. All models
All material © 2007. Martin Audio Ltd. Subject to change without notice. Note that all models are protected with a PTC (positive temperature coeffic
Suitable hole cutting methods will depend on the ceiling structure, local conditions, personnel, equipment etc and must be determined by the installe
Note that the tile rail ends may be reshaped to suit your particular ceiling structure. Tile rail end Step 3 Screw the C-bracket to the tile rail
2-way ceiling loudspeaker orientation Make sure that the C4.8T and C6.8T swivel-tabs do not coincide with the C-bracket gap. Loudspeaker in place
Step 5 Screw the loudspeaker to the C-bracket by tightening the screws from the underside of the baffle. Tightening the swivel-tab screws Step 6 C
The input and loop connectors must be fireproofed using the steel cover and screws provided. This cover has a 0.75” (19mm) knockout and a clamped cabl
Komentáře k této Příručce